top of page

MINUTEMAN RESCUE TRUCK

STANDARD FEATURES 

Steel body construction

STEEL BODY CONSTRUCTION

The custom-built body is fabricated from heavy channel iron and premium sheet steel with welded seams. All structural components of the bed are steel to comply with SAE J1194 for the Fire Attack Operational Areas in the BATROPS crosswalk.

BATROPS

BATROPS CROSSWALK

Directly aft of the chassis cab, the BATROPS (Blanchat Apparatus Transverse Roll-Over Protection System) is a transverse crosswalk which follow SAE International Surface Vehicle Standard #J1194 for roll-over protective structures.

Trans-Length Compartments

TRANS-LENGTH COMPARTMENTS

Trans-length compartments are fabricated into each side of the steel structure. They run the length of the bed, directly behind the BATROPS crosswalk to the rear bumper. Depending on which type of Minuteman is chosen, the compartments will have either one or two swing-up doors.

Rear access compartment storage

REAR ACCESS COMPARTMENT STORAGE

The incorporated side compartments have rear access to the top-most section for storage of shovels, pike poles, rescue braces, 12-foot extension ladders, backboards, etc. This storage area can be accessed on both sides via an aluminum tread plate flip-down door with quick release latches.

Top hose bed

TOP HOSE BED

A recessed top hose compartment above the tank is fitted with slatted, one inch pressure treated lumber to facilitate hose drying. The area extends from behind the pump panel to the rear of the bed.

Blanchat restraint system

BLANCHAT RESTRAINT SYSTEM

The Blanchat Restraint System is a 4-point full body harness which is attached within the BATROPS Fire Attack Operational Areas. It allows the firefighter to operate within the Fire Attack Operational Area from a seated or standing position.

Recessed poly tank

RECESSED POLY TANK

The tank is created by hand of polypropylene material that is several times stronger than standard propylene and features a lifetime warranty. The tank is recessed into the frame of the body for a low center of gravity.

Water Level Indicator

WATER LEVEL INDICATOR

A tankvision water level indicator is installed on the left side of the pump panel.

Hale HPX200

HALE HPX200 PUMP WITH BRIGGS 23 HP

The standard pump is a Hale HPX200 with Briggs & Stratton Vanguard 23 HP V-twin overhead valve engine. The pump performance is 200 GPM at 100 PSI and 300 GPM at 25 PSI. The pump has a hand priming system standard.

Pre-connected crosslay

PRE-CONNTECTED CROSSLAY

The 1-1/2-inch pre-connected crosslay hose bed is located behind the BATROPS crosswalk underneath the pump panel area. The hose bed is accessible from driver and passenger sides as well as from the BATROPS area.

Pump suction & drafting

PUMP SUCTION & DRAFTING

The plumbing tank to pump is 2-1/2 inch with one quarter turn valve. The plumbing from pump to draft is 2-1/2 inch with one quarter turn valve, 30 deg turn down, suction adapter and chrome plug with chain. With both valves open, the suction assembly will function as a quick fill.

Pump Panel

CUSTOM PUMP PANEL

The pump control panel is mounted in the BATROPS crosswalk for 360-degree visibility and to keep the operator free of surrounding threats. It has the following functions: pump start/stop, choke, pressure and throttle control, water level indicator and valve controls for all discharges. If a foam system or CAFS is installed, these controls and components are located in the pump panel.

Aluminum trim package

ALUMINUM TRIM PACKAGE

Aluminum is used when strength is not required to save weight or for aesthetic reasons. Aluminum tread plate “kick panels” are used throughout the BATROPS walkway area to minimize paint scratches.

Stainless trim package

STAINLESS TRIM PACKAGE

Stainless steel chip rails are used in high traffic areas such as under the doors to avoid chipping or scratching the paint.

Crosswalk folding step

CROSSWALK FOLDING STEP

There is a large chrome folding step recessed in the BATROPS walkway on the passenger side for top access.

Superliner coating package

SUPERLINER COATING PACKAGE

Superliner bed liner is applied to the crosslay and rear bumper to prevent paint chipping, rust and premature hose unloading.

Corashield coating package

CORASHIELD COATING PACKAGE

The underneath side of the bed is coated with Corashield to prevent, chipping, marring, rust, etc. of unpainted or painted surfaces after exposure to high impact sand, gravel or other abrasive materials.

Mud flaps

MUD FLAPS

Mud flaps are installed behind the rear tires.

Brush guard light bar mount

BRUSH GUARD LIGHT BAR MOUNT

The light bar mounting platform is constructed of steel and bolted directly to the headache rack with ample clearance from the top of the chassis cab. The platform is removable with plug and play electrical connections.

Emergency lighting

EMERGENCY LIGHTING

Eight red Whelen 500 series LED strobes are installed on the bed: two on the rear and three on each side including one in each cassis fender. The standard light bar is a Whelen 56” LED Justice with a total of eight red and two clear LED flashers.

DOT lighting

DOT LIGHTING

DOT running lights (amber and red LED) are installed around the bed. The rear bumper is equipped with four red stop/turn signal lights and two clear back up lights installed at a 45-degree angle. Three rectangular mini-LED lights to indicate an 8 foot or wider vehicle are installed in the center area as well as a license plate light.

Work light

WORK LIGHTS

Recessed work lighting is installed all around the apparatus to light important areas. These areas include the BATROPS walkway, pump panel and ground area, rear ground area, rear deck, and side compartments. If chosen as an option, top compartments will have interior work lighting.

Siren and speaker

SIREN & SPEAKER

The siren is a Whelen model 295HFSA1 with a SA315P projector speaker. The controls for the siren are located in the steering wheel as well as the dash mounted control box.

Door ajar system

DOOR AJAR SYSTEM

All four large compartment doors are wired so if a door is opened a red flashing LED light will activate in the cab within direct view of the driver.

dash mounted control box

DASH-MOUNTED CONTROL BOX

A dash top enclosure is standard which allows for the radio and siren mounting within easy view and reach of the driver. Mounting these controls on the dash keeps the center seat clear of equipment allowing a third person to ride in the front row.

Dedicated ground to battery

DEDICATED GROUND TO BATTERY

All grounds will terminate directly at the battery as well as in parallel at all lighting brackets which are frame grounded. Ground screws at lighting brackets are #10-24 stainless steel screws welded to the bracket, insuring a good ground to all electrical components even in the event of a ground failure.

reflective striping

REFLECTIVE STRIPING

Four inch reflective striping is applied to the lower body and rear bumper. A triple stripe is applied to the side of the chassis and the center of the fire body. Red/white diamond reflective tap is applied to the rear bumper. The striping color can be customized for each fire department.

Paint

PAINT

The steel structure is sandblasted to remove any mill scaling and provide for superior finish adhesion. Any bare steel not accessible will have two coats of primer applied before assembly to control corrosion. All bare steel will be coated with the appropriate primer/sealer and polyurethane acrylic enamel or equivalent finish to match fire department specifications.

  • Feature ordering follows the same order as the Blanchat Excel price sheet.

  • Click picture for enlargement.

Steel Body Construction (Minuteman Features)
Trans-Length Compartments (Minuteman Features)
Rear Access Compartment (minuteman feature)
Top Hose Bed (Minuteman Features)
Recessed Poly Tank (Minuteman Features)
Water Level Indicator (Minuteman Feature)
Hale HPX200 Pump (Minuteman Features)
Pre-Connected Crosslay (Mintueman Features)
Pump Suction & Drafting (Minuteman Features)
Custom Pump Panel (Minuteman Features)
Aluminum Trim Package (Mintueman Features)
Stainless Trim Package (Minuteman Features)
Crosswalk Folding Step (Minuteman Features)
Superliner Coating Package (Minuteman Features)
Corashield (Minuteman Features)
Mud Flaps (Mintueman Features)
Brush Guard Light Bar Mount (Minuteman Feautres)
Emergency Lighting (Minuteman Features)
DOT Lighting (Minuteman Features)
Work Lights (Minuteman Features)
Siren & Speaker (Minuteman Features)
Door Ajar System (Minuteman Features)
Dash Mounted Control Box (Minuteman Features)
Dedicated ground (Minuteman Features)
Reflective Striping (Minuteman Features)
Paint (Minuteman Features)
bottom of page